User guide

DEEP DRAGON Setup Page 37
 Latches. Once properly mated, secure the 3 latches. Visually inspect there are no
gaps around the perimeter.
 Mate Controls. At this time all controls can be pushed in. The Zoom and Iris
control must be rotated until it couples with the gear mechanism on the inside.
When properly mated, there is no gap between the Zoom / Iris control knobs and
the gland. Refer to photo.
If you do not have the LGD’s installed at this point, it will be necessary to hold the
shaft coupler at the front bulkhead and keep it from spinning while you mate the
controls.
 Mount the monitor. Secure the monitor to the top or rear of the main shell, as
desired and tighten the screws to secure.
Mate the shells
and close
latches. Inspect
the seal line for
gaps. Mate the
Zoom, Iris and
Power controls.
Mount the monitor
as desired (DEEP
RED shown)
Mate the Zoom and Iris
controls so they are fully
seated as shown.