User guide

DEEP DRAGON Setup Page 30
 Inspect the o-ring. As always, inspect the o-ring for foreign matter. Wipe your
finger around the silicone o-ring to clear away any dirt, hair, etc. DO NOT
LUBRICATE the silicone o-ring.
 Close the monitor shell. Mate the rear shell to the housing. Insert and tighten the
3 screws until snug. Tighten until there is no visible gap between shells. A good
indicator is when the orange o-ring is no longer visible.
 Plug in the external
monitor to the camera.
The procedure for
connecting to the
camera is identical to
the RED 5.6 in External
Monitor in the previous
section.
Inspect the o-ring. Wipe clean with your
finger to remove foreign material. DO
NOT lubricate orange o-rings.
Close the shell and
secure with 3 screws.
Tighten firmly, but do
not overtighten.
The RED PRO 5 in monitor will seat into
the front shell.