User guide

DEEP DRAGON Setup Page 27
 Close the monitor shell. Mate the rear shell to the housing. Insert and tighten the
4 screws until snug. Tighten until there is no visible gap between shells. A good
indicator is when the orange o-ring is no longer visible.
 Plug in the external monitor to the camera. The LEMO connection to the camera
is accomplished by passing the connector through the bulkhead opening on the
right side of the front shell. Pass the connector through then tighten the bulkhead
connection. Lastly, plug the connector into the camera LCD port.
See the section above “Camera / Lens Installation” for detail on connecting to the
EPIC camera.
Pass the right angle connector through
the bulkhead opening.
Close the shell and
secure with 4 screws.
Tighten firmly, but do
not overtighten.