User guide

DEEP DRAGON Setup Page 23
 Set the focus/iris indicators. The left side Focus control and right side Iris control
have focus and iris dials. These shipped in the parts kit. These may be aluminum
and pre-marked for the lens, or white plastic for marking focus / iris indications
yourself.
Rotate the focus or iris knob to either end of the lens travel, then position the
indicator ring to that setting aligned with the marker pin on the housing. Secure the
ring with the two set screws in the knob to retain. The indicator rings now display
lens settings on the knob during use.
 Verify Operation. Once positioned and secured check operation of the Focus and
Iris controls. They should rotate freely – but with slight resistance – in both
directions and through the entire range of travel. If not, repeat steps 1-3.
In a subsequent section “Check Operation” you will power on the camera and verify
the Zoom control is also smooth and operational.
Rotate the gear to either end of travel,
set the ring to the matching setting, then
secure with two set screws.