User guide

DEEP DRAGON Setup Page 21
Lens Gear Drives (LGD’s)
 General Notes. This section
addresses the installation of three
LGD’s – 2 x CCW (CounterClock
Wise) and 1 x CW (Clock Wise).
These designators are applied
because two LGD’s point in a CCW
direction and the other in a CW
direction, The LGD’s are marked
CCW and CW.
You will install guide bars and drive
shafts that match the lens of your
choice. A lens cross reference is
included in your DEEP DRAGON
documentation package and is
updated on a regular basis. Visit GatesHousings.com or contact Gates for a current
cross reference.
Secure Guide Bars. Insert the guide bars by threading them into the front
bulkhead. Tighten firmly by hand – no tools are required but wrench flats are
provided on the guide bars should this be necessary.
 Install Drive Shafts. These are ¼” black delrin and have a flat spot milled into one
end. This end inserts into the drive coupler at the face of the front bulkhead.
Secure gently with the set screw on the coupler. Do not overtighten.
DEEP DRAGON includes
three LGD’s – 2x CCW and 1x
CW.
Insert the drive shaft into the
coupler. One end of the shaft
will have a small flat spot.
Align this with the set screw,
and tighten gently. Do not
overtighten.
Note: DEEP RED shown
Thread the Guide Bar into the
front shell and tighten by
hand.