Specifications

RED DSMC OPERATION GUIDE

955-0020_V5.1, REV-A | 19

3. Place the MODULE ADAPTOR over the V-mount on the rear of the camera brain.

4. Use a T20 Torx driver to tighten the screws by about two turns in a cross pattern. DO NOT FULLY TIGHTEN.

5. Fully tighten the screws in a cross pattern. DO NOT OVERTIGHTEN.

ATTACH DSMC MODULE

WARNING: The DSMC modules are NOT HOT SWAPPABLE, meaning you cannot remove or install the modules

while the camera is powered on. Before installing or removing modules, you MUST power down the camera.

Failure to do so may result in damage to the modules or DSMC that will not be covered under warranty.

NOTE: The instructions below are applicable to all DSMC modules. The QUAD BATTERY MODULE is shown.

REQUIRED TOOL: T20 Torx

driver

MODULE ADAPTOR

Install Screws