MSDS

2
SECTION 5 – FIRE FIGHTING MEASURES
FLAMMABLE
Yes No
EXTINGUISHING
MEDIA
Carbon Dioxide, Dry Chemical, Foam
FLASHPOINT (°F) &
METHOD
>200F (Seta Closed Cup)
UPPER EXPLOSIVE LIMIT
(% BY VOLUME)
NE
LOWER EXPLOSIVE LIMIT
(% BY VOLUME)
NE
AUTOIGNITION
TEMPERTURE (°F)
NE
UNUSUAL FIRE & EXPLOSION
HAZARDS
None known.
SPECIAL
FIREFIGHTING
PROCEDURES
Wear self-contained breathing apparatus pressure demand (NIOSH approved or equivalent) & full protective gear. Use water spray to
cool exposed surfaces.
SECTION 6 – ACCIDENTAL RELEASE MEASURES
PROCEDURES
Wear proper protective equipment (Section 8). Use absorbent material or scrape up dried material & place in approved container.
SECTION 7 – HANDLING & STORAGE
HANDLING PROCEDURES &
EQUIPMENT
Keep out of reach of children & pets. Do not take internally. Do not breathe vapors. Use only w/ adequate ventilation. Wash
thoroughly after handling. Avoid contact w/ eyes, skin & clothing. Open windows & doors to ensure cross-ventilation &
fresh air during application & curing. Wash thoroughly after handling. Keep away from food, drink & animal feedstuffs.
STORAGE REQUIREMENTS
Close container after each use. Store containers away from excessive heat & freezing. Do not store @ temperatures above 120F. Store
away from caustics & oxidizers.
SECTION 8 – EXPOSURE CONTROL / PERSONAL PROTECTION
RESPIRATORY
If concentration exceeds exposure limits, a NIOSH-approved supplied air respirator is recommended. Where protection factor exceeded, a self contained
breathing apparatus (SCBA) may be required.
EYEWEAR
Goggles or safety glasses w/ side shields.
CLOTHING /
GLOVES
Rubber gloves (Neoprene recommended). If repeated or prolonged contact is likely, protective clothing such as boots, apron & face shield or goggles may be
required. Note: A safety shower & eye wash station is suggested, for immediate work area.
HYGENIC
PRACTICES
Remove & wash contaminated clothing before re-use. Wash hands before breaks & @ end of workday. Eating, drinking & smoking, while using product
should be prohibited.
SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE
Paste
ODOR &
APPEARANCE
Mild acrylic, light ammoniacal. Extra textured black paste.
SPECIFIC GRAVITY
Approximately 1.50 to 2.0
VAPOR DENSITY
(AIR=1)
Heavier than air
EVAPORATION RATE
NE
BOILING RANGE (°F)
NE
pH
Approximately 8 to 10
SOLUBILITY IN
WATER
Appreciable, before cure.
VAPOR PRESSURE (MM
Hg)
NE
%/WT VOLATILE
(TNV)
< 20
SECTION 10 – STABILITY AND REACTIVITY
STABILITY
Yes No
Stable under normal conditions.
INCOMPATABILITY
Yes No
Incompatible w/ strong bases & oxidizers.
CONDITIONS
TO AVOID
Excessive heat & freezing.
HAZARDOUS
POLYMERIZATION/HAZARDOUS
DECOMPOSITION PRODUCTS
Hazardous polymerization will not occur under normal conditions. Normal decomposition products, ie: COx, NOx.