Specifications

8
5.2.Master-slave operating
1.Unplug from the mains before installation.
2.Connect the LED modules to the xtures.
3.Connect the DMX output of the master xture in the data-chain with the DMX input of the rst slave. Always
connect output with the input of the next slave until all slaves are connected.Up to 32 xtures can be connected
in master/slave chain
4.Insert the termination plug (with 120 Ohm) into DMX input of the master xture and into the DMX output of
the last slave xture in the link in order to ensure proper transmission on the data link.
5.Connect the xtures to the mains.
6.See chapter "Stand-alone mode" in order to set the xture as a master or slave.