Specifications

9
5.3. Operating via DyNet protocol
1.Unplug from the mains before installation.
2.Connect LED modules to the xtures.
Connect rst xture to the control panel which uses DyNet protocol (e.g. DLP 8100)
3.Connect the DMX output of the rst xture in a data link with the DMX input of the second xture. Always
connect output with the input of the next xture until all xtures are connected.Up to 32 xtures can be con-
nected in data chain.
4.Insert the termination plug (with 120 Ohm) into DMX output of the last xture in order to ensure proper trans-
mission on the data link.
5.Connect xtures to the mains
6.Select the DyNet protocol on all xtures (menu "SPE"---> "Prt" ---->"dYn").