User manual

P a g e | 37
XXPRESS
USER MANUAL - 1.1
Figure 14b
• Figure 14b shows the confirmation screen that gives the user the
opportunity to review their experiment prior to running it. If anything
needs editing then touching the blue navigation bar on the bottom
will take the user back to the earlier screens so they can be edited
or checked as required.
• Once the user is happy that the experiment is correctly defined
then they can add the prepared test plate (see Section 7.2.4) with
the test samples in. To do this touch the Front Door Release
Button (See table 2) to open the units loading door.
• Place the prepared xxplate onto the slides ensuring that it
correctly located so the slides engage into all three holes on either
side of the xxplate.
• When correctly located close the door by pushing on the front of it
until it latches shut.
• Touch the forward arrow on the bottom right of the screen to start
the experiment.
• There are many other types of experiments that can be created on
the xxpress unit, however they all follow the same format and at
each stage all the parameters are available to edit.