Specifications

RED EPIC OPERATION GUIDE

955-0002_v4.0, Rev-A | 32

ATTACHING THE DSMC MODULE

WARNING: DSMC Modules are NOT hot swappable - meaning you cannot remove or install while the

camera is powered on. Before installing or removing a Module, you MUST power down the camera. Failure

to do so may result in damage to the Module and / or camera brain that is not covered by warranty.

Quad Battery Module shown.

Insert the lip at the top of the module into the recess at the top of the adaptor plate.

Insert Lip at Top of Adaptor Plate

Rotate Module Down Until Flush with Adaptor

Rotate module down flush with the rear of the adaptor plate.

Apply Steady Pressure