Specifications

RED EPIC OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC 955-0002_v4.0, Rev-A | 227
2. Power down both cameras, then power back up. If properly connected, LAN will illuminate Green on the
UI.
3. Connect a SYNC cable P/N 790-0154 to each camera and connect as to your 3
rd
party device.
A. Yellow BNC connector is for SMPTE unbalanced Timecode input.
B. Green BNC connector is for Tri-Level Sync (Genlock) input.
C. White BNC connector is a dual-purpose (Shutter SYNC input or GPI) input.
4. Go to SETTINGS > SETUP > GPIO/SYNC > SYNC MODE and select GENLOCK.
5. Verify the camera’s project frame rate matches the Genlock and Timecode generator(s) framerate(s).
6. When properly connected and synchronized, TC, GEN and SYNC will illuminate Green on the UI.
OPERATION
CHANGING SETTINGS
When changes are made to the Master camera settings, the Slave camera setting will also change, but not in
real-time. For example, when you change the Frame Rate on the Master camera, you will not see the change
on the Slave camera until you set the Master camera at the new Frame Rate.
Also when making changes to the Secondary menu settings, the Slave camera will not display those changes
unless it affects items displayed on the main screen (example: when HDRx is enabled on the Master camera,
HDR will change to HDRx on the Slave camera).
RECORDING
When the power/record button is pressed on the Master camera to start/stop recording, the Slave camera
will also start/stop recording.