Specifications

RED EPIC OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC 955-0002_v4.0, Rev-A | 151
7. Select OK.
Import calibration map procedure:
1. Go to SETTINGS > CALIBRATION.
2. In the Calibration Export/Apply section, select the calibration map you want to use.
3. Select one of the following:
Apply Permanently: The calibration map will be used until you select another calibration map, so even if you
shut down your camera, the calibration map will still be applied upon boot up. The import process takes
about 6 minutes. Do not shut down your camera during the import process.
Apply Temporarily: The calibration map will be used until you shut down the camera. The import process
takes about 30 seconds.
WARNING: Do not shut down your camera during the import process.