Technical data

Version 3.0
955-0002_V3.0, REV-A ©2011-2012 RED.COM INC.
27
QUAD BATTERY MODULE
Figure 10: Quad Battery Module – Side – Shown WITHOUT Batteries Installed
A
Battery Status LED
B
Battery Eject Button
• Battery Status LED: Indicate current status of corresponding battery.
• Battery Eject Button: Ejects corresponding battery to permit battery exchange.
INSTALLATION / REMOVAL
WARNING: THE QUAD BATTERY MODULE IS NOT HOT SWAPPABLE - MEANING YOU CANNOT
REMOVE OR INSTALL WHILE THE CAMERA IS POWERED ON. BEFORE INSTALLING OR
REMOVING THE QUAD BATTERY MODULE, YOU MUST POWER DOWN THE CAMERA. FAILURE
TO DO SO MAY RESULT IN DAMAGE TO THE QUAD BATTERY MODULE AND / OR CAMERA
BRAIN THAT IS NOT COVERED BY WARRANTY.
To install the Quad Battery Module to the camera, an Adaptor plate must be purchased seperately. The
following procedure details installation of the Adaptor Plate and Quad Battery Module:
1. Power down the camera if necessary.
2. Remove the REDmote if necessary.
A
A
B
B