Technical data

Version 3.0
955-0002_V3.0, REV-A ©2011-2012 RED.COM INC.
231
7. Insert a T-10 Torx® screwdriver into the back focus adjustment screw. The screw is oriented at
approximately 80° as shown.
Performing Back Focus Adjustment
8. Carefully and slowly, rotate the back focus adjustment screw to achieve optimum focus.
- Turning CLOCKWISE moves the sensor forward.
- Turning COUNTER-CLOCKWISE moves the sensor rearward.
NOTE: The center of the image will never be in perfect focus as the lines are less than 1/3 of a
pixel in size.
9. The back focus adjustment mechanism is self-locking, and does not require a supplementary locking
screw.
10. Install the screw-in plug in the back focus adjustment opening using a T-10 Torx driver.
11. This completes the RED EPIC back focus adjustment.