Installation & Assembly

Step 4
Place the chair on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the chair to some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the chair freely and vertically with the four legs, hitting the ground, at the same time.
This "drop" helps to ensure that all the bolts and gaps to all reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
Testagain
30cm‐ 50cm
Step 5
Test
again
for
evenness
on
a
LEVEL
SURFACE
.
If no wobbles found, proceed to fully tighten all the bolts.
CAUTION : When tightening these bolts, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the bolts and execute this same drop tests.
WARNING!! IF, THE CHAIR IS NOT STABLE , IT COULD LEAD TO DAMAGES IN THE
PRODUCT
Finally, seal the Seat Base Cover back on to the underside of the chair seat .
Turn it the right side up.
The chair is ready for use.
5 of 6