Caution : You must read this before you proceed.
Label Picture Description Qty A Chair Seat 1 B Back Wooden Leg 2 C Front Wooden Leg 2 D Seat Base Cover 1 Label Picture Description Qty a Bolt Dia.
Before Beginning Assembly: Unpack all the parts for a clear overview . Step 1 Position the Chair on its back, as shown. Preferrably on a surface that will not scratch the upholstery. Take out the 4 wooden legs and the package of hardware accessories under the chair seat.
Step 2 Pic. 1 Pic. 2 Place the chair onto the side of a table as seen in Picture(1) . You will now have the chair bottom facing skywards. Insert each Front Leg completely and vertically into each Front seat frame corner. PRESS FIRMLY DOWNWARDS with your hand until there is no gap. Affix the front legs with 4 Bolts (a) and 4 Spring Washers (b) and 4 Flat Washers (c) using the Allen key(d). DO NOT overtighten the bolts. WARNING!! DO NOT OVER TIGHTEN. OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
Step 4 Test again 30cm ‐ 50cm Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This "drop" helps to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, proceed to fully tighten all the bolts.
of 6
