Owner Manual

Page 5 of 6
Place the chair on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the chair to some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the chair freely and vertically with the four legs, hitting the ground, at
the same time.
This Drop Test will help to ensure that all the screws and gaps to all reach
If wobble
Test again
30CM~50CM
Step 4
full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles found, proceed to tighten all the screws.
CAUTION: When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the screws and execute this same drop
tests.
WARNING!! IF CHAIR IS NOT STABLE , IT COULD LEAD TO
Step 5
Ensure that all Screws are securely tightened.
Your Bar Stool is ready for use.