Owner Manual

ManualsBrandsRed Barrel Studio ManualsOutdoor & Patio FurnitureApryl 30" Patio Bar Stool

Table Of Contents

AI GHẾ BAR GỖ 11-2017.pdf (p.1-5)
- _
  - _
    - _
    - _
      - _
        _
        _
        _
        _
        _
AI.pdf (p.6)

Page 1 of 6

Assembly Instructions

Caution : You must read this before you proceed.

BAR STOOL

CAUTION : This PRODUCT is NOT a TOY.

Keep your child / children at bay in the process of

assembly.

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution : You must read this before you proceed. BAR STOOL CAUTION : This PRODUCT is NOT a TOY. Keep your child / children at bay in the process of assembly.
PAGE 2
Assembly Preparation Before Beginning Assembly: Parts List NO.
PAGE 3
Assembly Step Unpack and place all parts on a clean, non-marring surface. Place the Right Leg Panel(B) face up on its side. Align and insert Backrest Bar(D), Seat Support Bars(E) and Leg Support Rails(F) with tenons from the bars sitting snugly into Mortises on Right Leg Panel(B). Insert the Screws(G) through Mounting Positions on the Right Leg Panel(B) with Allen Key(H). Then repeat the same process for the Left Leg Panel(C).
PAGE 4
Step 3 Stand the Stool Frame up and place Seat(A) onto the Stool Frame. To affix the Seat to the Stool Frame, carefully lay down the Bar Stool and align the Mounting Position of the Stool Frame to the Mounting Positions at the Seat(A). Insert Screws(G) through the Mounting Positions with Allen Key(H) and slightly tighten the Screws. Then stand the Bar Stool up. Check both sides of Seat(A) are flush with the Stool Frame and tighten the Screws(G) sequentially.
PAGE 5
Step 4 If wobble Test again 30CM~50CM Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the screws and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE.
PAGE 6
Page 6 of 6