Assembly Instructions Caution: You must read this before you proceed Please look in the leg panel for hardware packs.
Parts List Label Picture Description QTY A Left Leg Panel 1 B Right Leg Panel 1 C Backrest Panel 1 D Seat Panel 1 E Leg Support Bar 2 F Seat Cushion 1 Description QTY ① Screw (M6x65mm) 11 ② Allen Key 1 Hardware Label Picture Page 2 of 8
Assembly Preparation Before Beginning Assembly: Page 3 of 8
Assembly Steps Overview Right Leg Panel (B) Backrest Panel (C) Left Leg Panel (A) Seat Cushion (F) Seat Panel (D) Leg Support Bar (E) FRONT FACING This Barstool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Barstool parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 2 2 1 B 2.2 C Iron dowel 2.1 Place the Right Leg Panel(B) at 90 degree as pictured above. 2.1) Insert prefixed iron dowel on Backrest Panel(C) into housing of Right Leg Panel(B). 2.2) Attach Backrest Panel(C) to Right Leg Panel(B) using Screws(①) with Allen Key(②). Do not fully tighten the Screws. Step 3 D B 1 2 Attach Seat Panel(D) to Right Leg Panel(B) using Screws(①) with Allen Key(②). Do not fully tighten Screws.
Step 4 B E 1 2 Attach Leg Support Bars(E) to Right Leg Panel(B) using Screws(①) with Allen Key(②). Do not fully tighten Screws. Step 5 A 2 C 1 E Iron dowel D B With assistance from your adult partner, carefully turn over the pre-assembled Barstool. Attach Left Leg Panel(A) to Seat Panel(D), Backrest Panel(C) and Leg Support Bars(E) using Screws(①) with Allen Key(②). Do not fully tighten the Screws.
Step 6 Stand the Barstool up, with assistance from your adult partner. Exert pressure floorwards, onto the Barstool with both your hands. This pressure will help the Legs and Barstool reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Screws in a sequential manner, until evenly secured. When tightening the Screws tighten sequentially. Do not tighten any Screw fully and then move on towards the next one.
Page 8 of 8
