Installation & Assembly

Step 3
Step 4
Attach Support Bar(C) to Iron Legs(B) using Bolts(①), and Washers(②) with Allen
Key(③) as pictured above.
Do not fully tighten the Bolts.
Stand the Bench right side up.
Place the Bench on a LEVEL surface.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit onto the Bench.
This pressure will help the Legs and Bench reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly
secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolts fully and then move on towards the next one.
Your Bench is ready for use.
This Bench can only be used on a flat, level surface.
3
1
2
B
C
B
Page 5 of 6