Installation & Assembly

ManualsBrandsRed Barrel Studio ManualsEight Person Patio Dining SetsEgina Rectangular 8 - Person 79'' Long Dining Set

Table Of Contents

Assembly Instructions

Caution: You must read this before you proceed

Bench

Caution: This Bench is NOT a TOY.

Keep your child/children at bay during the assembly process.

Whenever moving/lifting the Bench and to prevent damage to the Bench,

two adults are required to execute these actions.

Page 1 of 6

Please look in the iron leg for hardware packs.

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Please look in the iron leg for hardware packs. Bench Caution: This Bench is NOT a TOY. Keep your child/children at bay during the assembly process. Whenever moving/lifting the Bench and to prevent damage to the Bench, two adults are required to execute these actions.
PAGE 2
Part List Label Picture Description QTY A Seat Panel 1 B Iron Leg 2 C Support Bar 1 Description QTY ① Bolt (M8x20mm) 13 ② Washer (8.
PAGE 3
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview Seat Panel (A) Support Bar(C) Iron Leg (B) FRONT FACING This Bench has multiple parts and may require up to 15 minutes to assemble. To give you an overview of the Bench parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 3 1 B 2 A Place the Seat Panel(A) facedown onto a clean, non-marring surface. Attach Iron Legs(B) to Seat Panel(A) using Bolts(①) and Washers(②) with Allen Key(③). Note: The mounting positions on the Legs should face inside. Do not fully tighten the Bolts.
PAGE 5
Step 3 2 1 C B 3 B Attach Support Bar(C) to Iron Legs(B) using Bolts(①), and Washers(②) with Allen Key(③) as pictured above. Do not fully tighten the Bolts. Step 4 Stand the Bench right side up. Place the Bench on a LEVEL surface. Inspect it and make sure all parts are adequately connected. Gently and gracefully, sit onto the Bench. This pressure will help the Legs and Bench reach full alignment status. Check for wobbles on a LEVEL surface.
PAGE 6
Page 6 of 6