Owner Manual
5
IMPORTANT CONSIDERATIONS
AVOID AIMING THE SENSOR AT:
• Below are examples of objects that might produce heat and may cause the motion sensor to trigger:
• Pools of Water • Air Conditioners • Dryer Vents
• Animals • Heating Vents • Automobile Trac
If you suspect that a heat source of this type is triggering the motion sensor, reduce the sensitivity.
• Areas where pets or trac may trigger the motion sensor.
• Nearby large, light-colored objects reecting light may trigger the shut-o feature. Do not point other lights at the
motion sensor.
SEASONAL CHANGES:
e motion sensor works by sensing temperature changes across its eld of view. e closer the surrounding tempera-
ture is to a person’s body heat, the less sensitive the sensor will appear. e greater the temperature dierence, the more
sensitive the sensor will appear. e sensitivity (SENS) switch might need to be readjusted as the outside temperature
changes for the dierent seasons. is is a normal part of the light sensor’s operation.
DUALBRITE TIMER
DualBrite mode is a selectable feature that turns the light on at a reduced (accent) level at dusk. When motion is de-
tected, the light will increase to full bright for the amount of the ON-TIME setting (1, 5, or 20 minutes) then returns to
DualBrite mode. e light will stay on at the reduced light level for the amount of time selected (O, 3 hr., 6 hr., dusk-
to-dawn) and then turn o completely. Once the DualBrite timer runs out, the light will turn ON only when motion
is detected. Selecting OFF disables the DualBrite feature, however the motion sensing features will continue to work.
MANUAL MODE
Manual mode overrides the motion sensor and “ON-TIME” control so the
light will operate full bright. is feature only works at night and only for
one night at a time. e motion sensor will reset to motion sensing mode at
6 hours or sunrise, whichever comes rst. Manual mode can be toggled on
and o using a wall switch.
• To turn manual mode on, switch the light o at the wall switch for 1 to 2
seconds and then back on.
• To turn manual mode o, switch the light o at the wall switch for 1 to 2
seconds and then back on.
Turn the switch
OFF for 1 to 2
seconds
Turn the
switch
back ON