Assembly Instructions Required: Took Needed: Allen Key provided Please caver Forthwith conjugated cardboard rapes J carpet to avoid sandwiches { damages to floor
Step 1: locate parts P2 P92). & P7 Use colored rods to align pares for connection.
Step 2: Attach P7 and PO(2) to P2 with hardware as shown Loosely attach M2 and H3 bolts.
Step 4: Attach back deck P2 Use colored dots to align parts for connection. All bolts can be tightened at this point.
Step 5: Locate parts P5, PA(2). & P7 Use colored dots to align pares for connection.
Step 6: Attach P7 and PB(2) to P5 with hardware as shown Loosely attach M2 and H3 bolts.
Step 7: Attach seat deck P35 Use colored dots to alloy pants for connection. All bolts can be tightened at this point.
Step 8: Connect the fully assembled seat and back decks using hardware H5 (x2) as shown below
Step 11: Attach P10& with hardware as shown The bolts need To be very loosely attached al this point.
Step 12: Align H6M) into grooved out slots The bolts need to be very loosely attached at this point Tighten all bolts after shivering sin place.
Assembled views Your arm may vary.
