Installation & Assembly

Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
6103MM (1 SET)
Glass Shade
10093CS(3PCS)
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follow:
---Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
---Attach the fixture ground wire (green insulation or bare wire) to the mounting plate (A) with the green ground screw,
then connect it to the house ground wire with the wire connector (C).
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate (A) by inserting two fixture mounting screws (B), then secure it with two
ball nuts (F).
5. Attach the glass shade to fixture, then secure it with support rods (G).
6. Install three bulbs (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
Mounting Plate (A) Fixture Mounting Screw (D)Wire Connector
(C)
Lock Nut (E) Ball Nut (F) Support Rod (G)
Mounting Screw (B)