Warranty Information
LIMITED WARRANTY
Limited Warranty (“Warranty”): Subject to the exclusions set forth below, warrants that (i) all manufactured products will be 
free  from  defects  in  material  and  workmanship  which  cause  the  Products  to  fail  to  operate  in  accordance  with  the 
specifications set forth in the documentation published or provided with the Products (the “Specifications”) for a period of 
one (1) year from the date of shipment (“Non-LED Warranty Period”) and (ii) all light emitting diode (“LED”) Products, will be 
free  from  defects  in  material  and  workmanship  which  cause  the  Products  to  fail  to  operate  in  accordance  with  the 
Specifications  for  a  period  of  five  (5)  years  from  the  date  of  shipment  (“LED  Warranty  Period”).  For  purposes  of  this 
Warranty, references to “Warranty Period” shall refer to either the Non-LED Warranty Period or the LED Warranty Period, 
depending on the type of Product purchased by the End User. We warrants that any standard finish on a Product (other than 
Homestyle branded Products) will be free from cracking, peeling, excessive fading, and corrosion defects during the applicable 
Warranty Period. Extended warranties for fan motors and Energy Star® Products may apply; please refer to Product manuals for 
more information. For LED Products, the LED arrays in the Products will be considered defective in material or workmanship 
only if a total of 15% or more of the individual LEDs in the Products fail to illuminate.
Exclusions: This  Warranty  applies  only  when  the  Products  have  been  properly  handled,  stored,  wired,  transported, 
installed, operated and maintained in accordance with the applicable Specifications, including, without limitation, installation in 
applications in which ambient temperatures are within the range of specified operating temperatures and operation within the 
electrical values shown on the Specifications. We shall have no responsibility under this Warranty for any failure of the Products 
that  results  from  external  causes  including  without  limitation:   acts  of  nature;  physical  damage;  exposure  to  adverse  or 
hazardous  chemicals  or  other  substances;  use  of  reactive  cleaning  agents  and/or  harsh  chemicals  to  clean  the  Products; 
environmental  conditions;  vandalism;  fire;  power  failure,  improper  power  supply,  power  surges  or  dips,  and/or  excessive 
switching; fatigue failure or similar phenomena resulting from induced vibrations, harmonic oscillation or resonance associated 
with  movement  of  air  currents  around  the  Product;  animal  or  insect  activity;  fault  or  negligence  of  the  purchaser  of  the 
Products, any end user of the Products and/or any third parties not engaged by us, improper or unauthorized use, installation, 
handling,  storage,  alteration,  maintenance  or  service,  including  failure  to  abide  by  any  product  classifications  or 
certifications, or failure to comply with any applicable standards, codes, recommendations, product specification sheets, use 
of Products with products, processes or materials supplied by the purchaser of the Products,  any end user or third parties, or 
any  other  occurrences  beyond  reasonable  control.  In  addition,  we shall  have  no  responsibility  under  this  Warranty for  any 
substantial  deterioration  in  the  Product  finish  that  is  caused  by  failure  to  clean,  inspect  or  maintain  the  finish  of  the 
Products. During the Warranty Period some staining, chalking or fading may occur.  This is normal aging of the finish and is not 
a  manufacturing  defect; therefore  it  is  not  covered by  this  Warranty.   Neither  polycarbonate  nor  acrylic  material  used  in  the 
Products is warranted against yellowing, as yellowing may naturally occur over time due to normal aging. If the Products are 
used  on  existing  foundations,  anchorages  or  structures,  the  purchaser  of  the  Products  and/or  any  end  user  is  solely 
responsible for  the structural  integrity  of such  existing foundations,  anchorages  or structures  and all consequences  arising 
from their use. 
Adequate records (as determined by us in its sole discretion) of operating history, maintenance, and/or testing must be kept by 
the end user  and  provided to us upon request  to  substantiate that  the Products have failed  to  comply with  the terms of this 
Warranty. The Products are not warranted against costs that may be incurred in connection with changes or modifications to 
the  Products  required  to  accommodate  site  conditions  and/or  faulty  building  construction  or  design.   In  addition,  the 
Products are not warranted against cost resulting from installation of third party components, failures of third party supplied 
components,  or  failures  of  our supplied  Products  caused  by  third  party  supplied  components.   This  Warranty  is  not 
applicable  to  any  product(s)  which  are  not  installed  and  operated  in  accordance  with  the  current  edition  of  The  National 
Electric Code (NEC), the Standards for Safety of Underwriters’ Laboratory, Inc. (UL), or the standards for the American National 
Standards Institute (ANSI), and with instructions and guidelines for the Product. THIS WARRANTY IS VOID WITH RESPECT TO 
ANY PRODUCT IF THE PRODUCT IS NOT USED FOR THE PURPOSE FOR WHICH IT WAS DESIGNED OR IF ANY REPAIRS OR 
ALTERATIONS ARE MADE BY ANY PERSON NOT AUTHORIZED BY US IN WRITING.
Except as otherwise set forth herein, we does not warrant ballasts, battery packs, lamps, photocells, occupancy sensors, low 
voltage  indicators,  fuses,  surge  suppressors,  surge  protection  devices,  high  intensity  discharge  (“HID”)  components  and 
other  third  party  devices  that  are  not  manufactured  by  us,  which  are  covered  by  the  applicable  third  party  manufacturer 
warranty (if any).   Such third party manufacturer shall be solely responsible for the costs related to any claims associated with 
any such devices. Warping of wooden or plastic blades is not covered by this Warranty.  Metal finishes on Homestyle brand 
outdoor Products are not covered by this Warranty.
Remedy: If  the  Product(s)  fail  to  comply  with  the  terms  of  this  Warranty  and  the  end  user  (and  the  purchaser  of  the 
Product(s) if different from the end user) has fully complied with all of the obligations under this Warranty and the Terms and 
Conditions  of  Sale  including,  without  limitation,  payment  in  full  in  respect  of  the  Products,  at  its  sole  option,  will  repair  or 
replace the Product(s) with the same or a functionally equivalent Product(s) or component part(s).  Specifically, we will repair 
the  Product,  replace  with  a  similar  or  like  Product  (as  determined  by  us  in  its  sole  discretion),  or  issue  a  credit  to  the 
purchaser which may be used for future  product purchases. (The amount of such credit shall be calculated by us at its 
sole discretion). We reserves the right to use new, reconditioned, refurbished, repaired or remanufactured products or parts 
in the repair or replacement of any 


