Assembly Instruction

Figure 1
STEP 1 Attach Mirror with Backing to Mirror
Frame
-
A. Place the Mirror Frame (E) onto a flat working surface
with backing facing you.
B. Place the Mirror with Backing (D) onto the back of the
Mirror Frame (E). Align the Holes on Crossbars and
Mounting Holes on the Mirror Frame (E). Thread Lock
Screws (C) into Mounting Holes on the Mirror Frame (E)
to secure them together. Hand tighten until snug.
Mirror
Frame
Lock Screw
Mirror with
Backing
FOR VERTICAL
"A”
Floor
Surface
½ WIDTH
"B”
BACK
Crossbar
Figure 2
STEP 2 Mark Points for Mirror Hangers-
A. Lift and position where the Mirror will reside on the wall
surface and with a tape measure, mark distance from
floor to the bottom edge of the frame with a pencil. Mark
should be located at a point representing ½ of mirror
width.
B. Place the Mirror on a flat surface with back facing you.
Measure the distance from the bottom edge of the
Mirror Frame (E) to the bottom edge of the Crossbar.
This represents distance “B” in the illustration.
C. With tape measure, add this distance to Mark “A” on
wall surface and mark with pencil.
D. Measure distance between the centerline of (2) Side
Holes on the Crossbar. Add this ½ distance from Mark
“B” on each side and mark with pencil. (Distance “C” in
the illustration)
E. Measure 3” up from Mark “C” and mark. These marks
are locators for the (2) Mirror Hangers. Check for marks
straightness with level.
"C”
Crossbar
Side Holes
Assembly Instruction
3of5