Installation And Safety Instructions

ManualsBrandsRed Barrel Studio ManualsLantern Outdoor Wall LightingAtisha 100W 1-Light Outdoor Wall Lantern I

NOTE: This glass is handcrafted, the slight imperfections in

the glass add to the authenticity of the fixture.

FIGURE 1

IMPORTANT SAFETY INSTRUCTIONS

*NO

T INCLUDED

arefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1 & 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

ASSEMBLY

• Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing

nd create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

•

You don’t need special tools to install this fixture.

•

Be sure to follow the steps in the order given.

• Under no circumstances should a fixture be hung on house

electrical wires, nor should a swag type fixture be installed on a

eiling which contains a radiant type heating system.

•

Read instructions carefully.

• Proper wiring is essential for the safe operation of this fixture.

• Fixtures with photo-cells should be mounted at least 48" from all

sides to avoid reflection of light back onto Photo-cell, causing the

Photo-cell to malfunction or flicker.

• To reduce the risk of fire, electric shock, or personal injury, mount

to outlet box or supporting system able to support the weight of

the fixture.

• Save these instructions.

GLASS (P)

*WIRE

CONNECTORS

MOUNTING

BAR

OFFSET

STRAP (C)

MOUNTING

BAR FLAT

STRAP (B)

FIXTURE

MOUNTING

SCREWS (I)

*OUTLET BOX

CAP

NUTS (E)

BALL

STUDS (R)

CAGE (F)

FINIAL (Y)

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

STEP 1:

GREEN

GROUNDING

SCREW (L)

NOTE: FOR FIXTURES LABELED FOR WET LOCATION AND

USED OUTDOORS.

CAUTION:

To reduce the risk of electrical shock, provide a

watertight seal between the fixture and the mounting surface by

using a silicone or similar caulking.

BOTTOM

HOOD (M)

BACKPLA

(M)

Summary of content (2 pages)

PAGE 1
Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • • • • ASSEMBLY Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off.
PAGE 2
INSTALLATION STEP 5: IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Hold mounting bar with flat strap (B) behind offset strap (C). Rotate straps so they are at right angles to one another. STEP 2: Insert fixture mounting screws (I) in threaded holes of offset strap (C). Run fixture mounting screws (I) all the way down to the heads. GROUNDING INSTRUCTIONS: The green grounding screw (L) is to be inserted into the hole with two raised dimples provided on the mounting bar.