Assembly & Installation Instructions
4. Thread the fixture wire through the coupling kit, collar, canopy, then secure the rod assembly to the coupling kit.
5. Thread the fixture wire through the hex nut, threaded pipe and mounting strap. Install the hex nut onto one end of the
threaded pipe leaving about 3/8” (10mm) thread exposed. Install same end of threaded pipe by screwing into coupling kit,
secure threaded pipe by tightening hex nut.
6. Attach the threaded pipe to the mounting strap, then secure it with a washer and hex nut.
7. Attach the mounting strap to outlet box by using two mounting screws.
8. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture to the hot wire (usually black insulation) from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the neutral wire (usually white insulation) from the power
source.
---Attach the fixture grounding wire (usually bare wire) to the mounting strap with the green grounding screw. Then connect
it to the house grounding wire with a wire nut. If your outlet box does not have a house grounding wire, then wrap the
fixture grounding wire around the green grounding screw.
Carefully put the wires back into the outlet box.
9. Attach the canopy to the mounting strap: insert the coupling kit
through hole, then secure by tightening collar.
10. Place the glass shades onto the glass
bracket
s, then secure them
by tightening the spacers and socket rings.
11. Install bulbs (not included). See relamping label at socket area or
packaging for maximum allowed wattage.
12. Angled mounting recommended for a vaulted or angled
ceiling. (See Fig. 1)
Turn on the power at the main fuse or circuit breaker box.
Fig.1
Outlet Box
Support Brace
Canopy
Coupling Kit
The following parts are available for re-order if damaged or missing.
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Hex Nut (D)
Wire Nut (E)
Canopy (G)
Coupling Kit (H)
Collar (I)
Threaded Pipe (F)
Washer (J)
Page 2
A: 15-1/2"
B: 20-1/2~74-1/2"
Spacer (L)
(6 PCS)
Glass Shade (K)
(6 PCS)
Assembly Kit
(1 SET)
12”Rod (M)
(4 PCS)
6”Rod (N)
(1 PC)
3”Rod (O)
(1 PC)