Assembly & Installation Instructions

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box.
Page 1
1. Carefully remove the fixture from the carton and check that all
parts are included.
2. Thread the center stem onto the coupling on the top center of
the fixture
3. Rod Connections:
a. Thread the fixture wire from the fixture through the 3" rod,
then secure 3" rod onto center stem using threaded pipe.
b. Thread the fixture wire through the middle rod, then secure
middle rod onto 3" rod using threaded pipe.
c. Thread the fixture wire through the upper rod, then secure
upper rod onto middle rod using threaded pipe.
"NOTE: Length adjustable from 20-1/4" to 74-1/4". Use
fewer rods if shorter length is desired.
4. Thread the fixture wire through
the coupling kit, collar, canopy,
then secure the rod assembly
to the coupling kit.
5. Thread the fixture wire through
the hex nut, threaded pipe and
mounting strap. Install the hex
nut onto one end of the threaded
pipe leaving about 3/8” (10mm)
thread exposed. Install same
end of threaded pipe by
screwing into coupling kit, secure
threaded pipe by tightening hex nut.
Collar (I)
Canopy (G)
Outlet Box
House Grounding Wire
Wire Nut (E)
Threaded Pipe (F)
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Upper Rod
Middle Rod
3" Rod
Coupling
Threaded Pipe
Fixture Wire
Coupling Kit (H)
Fixture Grounding Wire
Hex Nut (D)
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Hex Nut (D)
Wire Nut (E)
Canopy (G)
Coupling Kit (H)
Collar (I)
Hex Nut (D)
Hardware Package (included):
Assembly Instructions:
Washer (J)
Threaded Pipe (F)
Spacer (L)
Glass bracket
Socket Ring
Bulb Type A Max.100W
(not included)
Socket
Glass Shade (K)
Center Stem
Washer (J)