Assembly Instructions

HARDWARE IDENTIFICATION
A DRESSER 1SET 1
SHORT SCREW
1PC
2
LONG SCREW
1PC
3
CABLE TIE
1PC
4
L BRACKET
2PCS
STEP 2
Locate the other bracket on the wall over a wall stud and two
inches below the mounting bracket secured to the back of
dresser. Attached to the wall stud using the long screw
provided, through the smaller hole.
PARTS IDENTIFICATION
ANTI-TIPPING KIT
STEP 3
Place the dresser into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through the
larger hole in each mounting bracket. Bring both ends together and slide the flat end through the locking end and draw it
through until all slack is removed. Confirm that the strap is securely laced and locked
PAGE 3 OF 3
STEP 1
This tip restraint must be attached to a wall stud
using long
screw enclosed.
Attach a bracket securely to the back top rail of the dresser
using short screw provided, through the smaller hole.