Installation & Assembly

Step 4
Step 5
Stand the Chair up, and attach the Right Armrest/Leg(B) to Backrest(D) using Bolt(⑤)
and Washer(②) with Allen Key(④) as shown in Picture.
Tighten all Bolts at all joints sequentially.
DO NOT tighten any Bolt fully and then move on to the next one. This may cause
the frame to warp. If the Chair is not stable it could lead to damage to the
product.
Adjust the pre-installed Levelers at the end of each Chair Leg until the Chair is level
with the ground.
Put the Nut Cap (③) as shown in Picture.
Then put the Seat Cushion(E) on the Chair.
Your Chair is ready for use.
This Chair can only be used on the flat and level surface.
Page 5 OF 6