Assembly Instructions

Unless you are particularly adept at assembling flat-pack/knock-down
furniture, we understand building ready-to-assemble furniture can be a
frustrating experience for some. To help avoid confusion and to make
the assembly process quicker and smoother, we have provided some
helpful tips. Before you begin the assembly, please read the following:
1. Due to the size and/or weight on most of the ready-to-assemble furniture, it is
highly recommended that the assembly should be done near the area of its
intended location.
Make sure you have enough space to
move around during
the assembly
. ALWAYS have at least two people to help with
transporting and
assembling of the product
to avoid any potential injury and/or damage.
2. To protect from damage, assemble the item on a clean, protective surface,
such as on a carpet or cardboard.
3.
Make sure you have taken all the parts and hardware out of
their packaging.
Do
not throw away packaging material until assembly is completed.
4. Make sure all
parts and hardware are accounted for by comparing the actual
parts and hardware to the list provided in the assembly instructions. Also
check for any irregularity such as
crack, flaw or improperly drilled hole. If
there
is any problem
or missing piece, pl
ease contact the manufacturer or the
supplier
. Please have the model number, part number and a
brief description
of the problem
ready will help expedite the
replacement process.
5. Read the entire instruction manual and view the diagrams first before
assembling.
Arrange your parts in
order of use and group the identical
hardware
together to make it easier to grab each piece as you begin
to
assemble.
6.
During the assembly process, make sure all
parts are properly aligned before
tightening with the tool provided or required for the assembly. Do not use
power tools and do not over tighten.
7.
When applying glue to the wood dowels to bond the parts together, please
be
ABSOLUTEL
Y certain that the parts are correct and lined up with
each other
(refer to diagrams and take notice of the various pre-drilled hole locations).
When in doubt, assemble the parts together first and if the parts fit right, then
apply glue to the wood dowels.
PRE-ASSEMBLY INTRODUCTION