Installation & Assembly

4
5. HANGING THE FAN
REMEMBER to turn off the power. Follow the steps
below to hang your fan properly.
NOTE: This ceiling fan is supplied with two types of
hanging assemblies; the standard ceiling installation
using the downrod with ball and socket mounting
and the "close-to-ceiling" installation. The
"close-to-ceiling" installation is recommended in
rooms with less than 8-feet ceilings or in areas
where additional space is desired from the floor to
the fan blades.
STANDARD CEILING INSTALLATION
Step 1. Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as shown in
Fig. 5.
Step 2. Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 3. Remove the hanger pin, lock pin and set
screws from the downrod assembly.
Step 4. Route wires exiting from the top of the fan
motor through the canopy and then through the
ball/downrod. (Fig. 6)
Step 5. Align the holes at the bottom of the downrod
with the holes in the collar on top of the motor
housing. Carefully insert the hanger pin through the
holes in the collar and downrod. Be careful not to
jam the pin against the wiring inside the downrod.
Insert the lock pin through the hole near the end of
the hanger pin until it snaps into its locked position.
(Fig. 6)
Step 6. Tighten two set screws on top of the fan
motor firmly.
Step 7. Place the downrod ball into the hanger
bracket socket. This will allow you to make the
electrical connections. (Fig. 7)
Mounting screws
(supplied with
electrical box)
Hook
Ceiling
hanger
bracket
UL Listed
electrial
box
Figure 5
Figure 6
120V Wires
Washers
Downrod
Canopy
Set screws
Hanger pin
Lock pin
Figure 7
Registration slot