Installation & Assembly

Step 6

Step 7

Put the Seat Cushion(E) on the Seat.

Your Chair is ready for use.

The Chair can only be used on the flat and level surface.

Page 5 OF 6

Drop the Single Chair freely and vertically with all four legs, hitting the ground, all at

the same time.

This Drop Test will help to ensure that all the Bolts and gaps reach full alignment

status.

Test again for evenness on a LEVEL SURFACE.

If no wobbles are found, slowly and steadily, place the Single Chair facedown.

Then, proceed to tighten all Bolts in a sequential manner.

When tightening the Bolts, tighten sequentially.

DO NOT tighten any Bolt fully and then move on towards the next one.

This could cause the frame to warp. If there are still wobbles, loosen the Bolts and

execute the same drop test.

If the Single Chair is not stable, it could lead to damage to the product.

And place PE Caps( ) on Bolts as shown.