User`s guide

Version: 1.1

User’s Guide

Recordex StudioJet

Accessing Printer Driver Preferences

These utilities will help you to test and maintain your

printer.

Test Print: Prints an alignment image that is 116mm in

diameter to assist with changing printer alignment

settings.

Clean: At times, especially if the printer has not been

used for a while, the ink nozzles will need to be cleaned.

The clean utility will clean out the nozzles.

Demo Print: The demo print button will send a photo

print job to the printer. This is an easy way to verify

that the printer is working properly.

Ink Level: The ink level indicator will only work while the

printer is printing. These levels are not always 100%

accurate. We recommend running cartridges until they

no longer print properly before replacing them.

Your StudioJet like any automated disc printer may

require minor alignment after shipping or being moved.

If you notice a consistent misalignment of the print image

you should alter center offset of the printer.

First go to the Utilities tab and print a Test Print which

will print a disc with an alignment pattern. If the outside

diameter circle is not centered then adjust the offset

accordingly:

Move Up: Enter a negative value in the Y offset and

click offset.

Move Down: Enter a positive value in the Y offset and

click offset.

Move Right: Enter a positive value in the X offset and

click offset.

Move Left: Enter a negative value in the X offset and

click offset.

Figure 4.7: Utilities

Figure 4.8: Alignment

Note: That the Ink Level utility will

not work if you have your printer connected

to the network with a wireless print server.

Note: To save an offset value you

must click the Offset button. Clicking OK

will not save an offset change.