Instruction manual

33
11. Maintenance
• Make all adjustments or machine maintenance with the
machine unplugged from the power source.
• Repair and maintenance work on the electrical system
may only be carried out by a qualified electrician.
• All protective and safety devices must be re-attached
immediately after completed cleaning, repair and
maintenance work.
• Defective safety devices must be replaced immediately.
Cleaning
• Regularly change the water in the water tank.
• Regularly clean the machine housing with a soft cloth
preferably after each use.
• If the dirt does not come off use a soft cloth moistened
with soapy water.
• Never use solvents such as petrol, alcohol, ammonia
water, etc.
• These solvents may damage the plastic parts.
• To protect your sharpener from dust and damage when
not in use, an optional heavy duty cloth cover, WG250/Q
is available. Please contact your local retailer or visit the
Record Power website for further details.
Storage
• The machine has an integrated storage drawer
• The angle finder (T) will stick to the magnets on the
designated place at the side of the machine.
• The angle setting gauge (S) has integrated magnets and
will stick to the machine body at any place.
Inspecting the brushes
• Disconnect from power source, unplug!
• Inspect the motor brushes after 300 hours of use.
• If the brushes are worn to 6 mm replace them.
Always replace the brushes in pairs.