Instruction manual

29
10.8. WG250/C Straight Edge Jig
Getting to Know the Straight Edge Jig
The straight edge jig slides on to the support arm of your wet
stone sharpener.
The straight edge jig aligns the tool automatically to its
upper and flat side.
A. Clamp
B. Lock knob
A B
Using the Straight Edge Jig
1. Mount the support arm in the upper position.
2. Slide your tool to the edge of the clamp and lock in place
with the lock knobs.
3. Do not over tighten central lock knob as this will cause
the tool to twist in clamp.
4. Slide the straight edge jig on to the support arm.
5. To set the angle use the angle setting gauge and adjust
by raising or lowering the support arm.
6. Move the tool slowly back and forth across the
Sharpening Stone when in motion.
7. To finish hone your blade on the leather honing wheel,
see page 11.
A B
A B
Use to sharpen:
• Plane irons
• Bevel edge chisels