User manual

FAQs / Troubleshooting
Why can’t my computer detect the Command Monitoring Station?
 Make sure that the CMS Receiver is connected to a USB 2.0
port.
 Make sure that your system has updated USB host drivers.
 Make sure the CMS Receiver power is on.
Why isn’t the application displaying video from the robot?
First, make sure that your robot is active and transmitting video. Check
that:
 The robot has been activated (pin out).
 The OCU screen is displaying video from the robot.
Next, test your Command Monitoring Station setup. Is the CMS
Receiver:
 Turned on? (Channel selection LED will be lit up)
 Set to the same channel as the active robot?
 Attached by cable to the Yagi antenna?
 Plugged into a computer with the USB cable?
Why isn’t the application playing audio?
Only Throwbot XT Audio robots are capable of transmitting an
audio signal from the robot to the CMS 2.0 and OCU. Look for the
microphone sticker on your robot to verify that audio is available:
If the CMS 2.0 is not tuned to the same channel as an active audio
robot, it will play static on the audio channel. Check that:
The selected channel on the CMS 2.0 matches the robot channel
Volume is turned up on CMS Software
Volume is turned up in operating system
Speakers are set up and turned on
Page 10