User manual

Remote

PAIRING A REMOTE CONTROLLER

Followthesestepswhenyouunpairedaremotecontroller

bymistake,performedafactoryreset,boughtorborroweda

replacement MOD or MOD Live unit.



1. Lookonthebackoftheremotecontrollerfortheserial

number printed on a white label. Note the ID number.

2. IfMODLiveisturnedon,turnothepowerbuon,wait

forafewseconds,andthenturnthepowerbuonbackon.





3. PresstheMODLivepowerbuontonavigatetothe

remoteIDthatcorrespondstoyourremotecontroller.Each

pressofthepowerbuonwilltakeyoudowntothenextID

on the list.

4. Waitforthecountertoreach0,andthenpressanybuon

on the remote.

5. Waitforabluelighttoashontheremote.

6. Checkthattheremoteispairedbylookingatthestatusbar.

Waitfortheremoteconneconindicatoricontoturnblue.