User manual

Page 6 MOD User Manual | January 2012 | © 2012 Recon Instruments Inc | All rights reserved | www.reconinstruments.com
To charge MOD using an AC adapter:
1. AssembletheACadapterbyinserngtheNorth
American or European plug. Insert the large plug of the
USBcableintotheadapterport.
2. RemovetheclearplasccapthatcoverstheMODUSB
port.
3. Insert the smaller plug into MOD’s USB port. Tip: the
portcovershowsanyimageofaUSBcable.Check
thattheplug’s7Lleeringappearsontheoutsideof
the goggle.
4. Plug the adapter into a power outlet. As soon as MOD
beginscharging,aredlightappearsdirectlyabovethe
USB port.
5. Aertheredlightdisappears,disconnecttheadapter.
RemovetheUSBcablefromMOD.
6. SealtheUSBportwiththeplasccap,thenghtlypush
down on the USB cover to ensure no rain, snow or ice
aectstheport.
Charge up MOD
To ensure that MOD is fully charged, follow these steps using the MOD AC adapter and
microUSBcable.TheMODpowerbuon(besidetheUSBport)mustbeturnedowhile
recharging.