User manual

Page 50 MOD User Manual | January 2012 | © 2012 Recon Instruments Inc | All rights reserved | www.reconinstruments.com
Remote
Pairing a remote controller
Follow these steps when you unpaired a remote controller
bymistake,performedafactoryreset,boughtorborroweda
replacement MOD or MOD Live unit.
To pair the remote controller with MOD:
1. Lookonthebackoftheremotecontrollerfortheserial
numberprintedonawhitelabel.NotetheIDnumber.
2. IfMODisturnedon,turnothepowerbuon,waitfora
fewseconds,andthenturnthepowerbuonbackon.Wait
fortheprompttopresstheMODpowerbuon.Thisprompt
mayshowoneormoreremoteIDnumbers.
3. PresstheMODpowerbuontonavigatetotheremoteID
that corresponds to your remote controller. Each press of
thepowerbuonwilltakeyoudowntothenextIDonthe
list.
4. Waitforthecountertoreach0,andthenpressanybuon
on the remote.
5. Waitforabluelighttoashontheremote.
6. Checkthattheremoteispairedbylookingatthestatusbar.
Theremoteconneconindicatoriconshouldturnblue.
Itcantake10secondsfortheremoteindicatortoturnblue.