User manual

1. Remove the lens from the goggle

frame.Seeinstruconsprovidedby

the goggle manufacturer.

2. On the frame of your goggles, remove

theprotecvebadgefromthele

side of the frame. This will reveal slots

forMODtobeinserted.

3. Next,insertMODintothegoggle

frame as follows: with the goggles

facing you, snap the MOD micro

opcsdisplayunitintotheleinner

corneroftheframe.Next,insertthe

baerypackintotherightcorner.

4. PushtheMODcableintothegroove

sothatittsghtly.

5. Ifthecableistooshort,tugitgently

so the white stripes appear. If the

cableistoolong,pushitbackin.

6. Insertthelensbackintothegoggles.

Takecarenottotouchorsmudge

the lens.

Follow these steps to snap MOD into your goggles. Note: only use goggles that are Recon-

Ready®.Our2011ReconReady™partnersincludeUvex®,Briko®,Zeal®,andAlpina®.To

learnmoreaboutRecon-Readygoggles,goto:www.ReconReady.com

Snap MOD into goggles