User manual

Page 47 MOD User Manual | January 2012 | © 2012 Recon Instruments Inc | All rights reserved | www.reconinstruments.com
Baery
TochargeusingaPCorMac:
1. Makesureyourcomputeristurnedon,
andnotinstand-bymode.
2. MakesureMODisturnedo.IfMODis
on,holddowntheMODpowerbuon
for2seconds.ConnecttheUSBcable
shipped with MOD. Plug the micro USB
cable’ssmallerendintothemicroUSB
portlocatedundertheprotecvecover
on the right side of the goggles. Plug the
USBcable’slargerendintotheUSBport
in your PC or Mac. Tip: If your computer
doesnotrecognizeMOD,tryreinserng
theUSBcable.
3. CheckthataredlightabovetheUSB
port appears. This shows that MOD is
charging.TheredUSBportlightturnso
when MOD is charged.
Tochargeusingapoweroutlet:
1. ConnecttheUSBcableshippedwith
MOD.PlugthemicroUSBcable’ssmaller
end into the micro USB port located
undertheprotecvecoverontheright
side of the goggles
2. PlugtheUSBcable’slargerendinto
either the North American or European
AC adapter shipped with your unit.
3. Plug the AC adapter into a wall outlet.
4. CheckthataredlightabovetheUSB
port appears. This shows that MOD is
charging.KeepchargingunltheredUSB
portlightturnso(whichindicatesMOD
is fully charged).