Owner's manual



General Installation Notes for all RECON LED Load Resistors
Due to the low resistance nature of Light Emitting Diode (LED) technology, most automobiles & other 12-volt related vehicular applications such
as Motorcycle, ATV’s, Side-by-Sides, RV’s, Golf Carts, etc., will require the use of a special load resistor to prevent a turn signal from blinking
rapidly (which is an indication that a bulb is out or even a warning signal may show on the vehicles dashboard.) To solve this issue, RECON
produces a special “heavy-duty” 50 Watt 6 Ohm LED load resistor & a “light-duty” 25 Watt 3 Ohm LED load resistor which each draw the
equivalent amount of current of a standard halogen / incandescent bulb. The installation of these LED load resistors is a very simple and straight
forward process as indicated below.
Install instructions for part #’s 26410 & 26420 – LED Load Resistors for use with RECON LED Bulbs
Step1) Layoutthepartsincludedintheboxandensureyou havetwo(2)quickconnectwirespliceclips&one(1)50Watt6OhmRECONLoad
Resistor(screwsarenotincluded
Step2) AfterinstallingtheLEDbulbinplaceofthestandardhalogen/incandescentbulb,locatethepositiveturnsignalwire&spliceoneendof
theresistorintothiswire.
Step3) Locatetheoppositewirecomingofftheoppositeendoftheresistor&groundthiswiretothechassisofthevehicle.(DONOTSPLICETHIS
REMAININGWIREONTHELOADRESISTORTOTHENEGATIVEWIRECOMINGOFFTHEBULB.)
Step4) Usingsmallsheetmetalorequivalentscrews(whicharenotincluded),besuretomounttheRECONLEDLoadResistortoametalsection
of the chassis which can easily withstand the high temperatures generated by the LED Load Resistor. This resistor can reach constant
operatingtemperaturesofupto
250DegreesFahrenheit.
Step5) Install both Driver side & Passenger side LED bulbs and one (1) load resistor on each positive wire coming off of each bulb before
attempting to test the function of the turn signals or other bulbs that have been changed to LED from halogen / incandescent. After
confirmingthateachLEDbulbhasaRECONLEDloadresistorinstalledanditisproperlywiredintoit,youmaythenconductatestofthe
LEDbulbsinstalledonthevehicle.
If you have any questions, feel free to contact us:
[e-mail] - www.GoRECON.com