Installation Manual

INSTALLATION INSTRUCTION
Prior to the installation of your RECON LED tail lights, please follow the instructions below to prevent a short
circuit situation in your vehicles electrical system which will cause fuses to blow on your fuse panel.
(a) Install the function of Brake/Position light:
Please follow the directions and color of the wires (shown in Pic. 1). Connect the connector with the
corresponding wire color. (black wire goes in-line with black wire)
Pic. 1. The wire harness for the Brake/Running Light Function
Black wires
Bla
ck wires
From tail light
From the vehicle
Remove your factory taillights by lowering the
tailgate and removing the two screws
that hold each light in place.
Pull the light away from the truck by the outer edge
Untwist the bulb sockets from the
factory lens, keeping all wiring intact
Lock the reverse socket with bulb(or LED bulb if you ordered those) into your new
R
ECON taillight’s reverse socket
Remove the factory bulb from the taillight socket
and then insert our plug into the vacant
bulb socket on the factory harness, please make sure to keep the black wires on the
RECON harness on the same side as the black wires on the stock socket.
Make sure the lock the
factory socket(with RECON plug inserted) into the opening on
the RECON taillight to seal the light
Make sure that you do not over eghten the screws when pumng
the lights back onto
your truck
HOW TO CONNECT THE WIRING HARNESSES ON RECON LED TAIL LIGHTS
1
2
3
4
5
6
7