Datasheet

www.recom-power.com
REV.: 0/2019 P-3
Evaluation Module
Specifications (measured @ Ta= 25°C, full load after warm up unless otherwise stated)
RPMB-2.0-EVM-1
L4
C4
1210
C10
1206
C12
1210
R2
0603
L2 1206
C1
E1
E4
E2
D1
E5
C5
TRIM
GND
GND
GND GND
V
OUT
V
IN
CTRL
SENSE
NC
NC
PGOOD
U1
L1
L3
C3
1210
C11
1210
C2
1210
C8
1206
C7
1210
R1
0603
C1
1210
C9
1210
C5
1210
C6
1206
R5
0603
C1
R4
0603
R6
0603
V
OUT
CTRL
V
IN
SEQ
SENSE
V
OUT
R9
0603
R10
0603
L9
L7 0805
L8
L5
L6
Schematic
Description
U1: RPMB-2.0 power module.
C1, C2, C3, C11, L1, L2, L3, L4, C4, C5, C12: allow placement of various sized components to test input filter design. The populated filter is
designed to meet EN55032 class B ew
C6, C7, L5, L6, L7, L8, L9, C8, C9: allow placement of various sized components to test output filter design. The populated filter is designed to
meet EN55032 class B
R5: connect 0Ω resistor to disable the module. This resistor is not populated.
C10: not applicable for RPMB-2.0-EVM-1
R9 and R10: leave open (RPMB-2.0 has PGOOD internally pulled up to 5V)
R1: populated 0Ω resistor for direct output voltage measurement. If sense is desired at a different location, for example after the filter or directly
at the load, remove R1, and connect sense to the new measurement point.
R2: sense point for output voltage after the filter. To set sense point here, remove R1 and solder a 0Ω resistor at R2.
R4 and R6: trim the output voltage. Refer to
“OUTPUT VOLTAGE TRIMMING”
Notes:
Note1: Grey colored components are not mounted
Preliminary