Datasheet

RCD-PL
LIGHTLINE
DC/DC-Converter
RCD-24-PL
Series
Specifications (typical at 25°C, nominal input voltage, rated output current unless otherwise specified )
Dimensions 31.0 x 11.4 x 6.6mm
Weight 1.9g
Packing Quantity 12 pcs per Tube / 400 pcs per Reel
Reflow Soldering Profile 265°C/10 sec max
MTBF (using MIL HDBK 217F) +25°C >600 khours
PWM Dimming and ON/OFF Control (Leave open if not used)
Remote ON/OFF DC/DC ON Open or 0V<Vr<0.6V
Threshold Voltages DC/DC OFF (Standby) 0.6<Vr<2.9V
DC/DC OFF (Full Shutdown) 2.9V<Vr<6V
Remote Pin Drive Current Vr=5V 1mA max
Quiescent Input Current in Shutdown Mode Vin=36V 200μA max
Recommended PWM Frequency For Linear Operation 200Hz
(measured 10%~90% Dimming) Maximum Frequency 1000Hz
Analogue Dimming Control (leave open if not used)
Input Voltage Range 300-1000mA -0.3V - 15V
Control Voltage Range Limits (see Graph) 300-1000mA / Full On 0.13V ± 50mV
300-700mA / Full Off 4.2V ± 150mV
1000mA / Full Off 4.35V ±100mV
Analogue Pin Drive Current 300-1000mA / Vc=5V 0.2mA max.
Environmental
Shock / Vibration EN61373
EMC Railways EN50121-3-2:2006
Conducted Emissions 300-1000mA (/A Suffix) EN55022, Class A
300-700mA (/B Suffix) EN55022, Class B
Radiated Emissions EN55022, Class B
ESD EN61000-4-2, Criterion A
Radiated Immunity EN61000-4-3, Criterion A
Fast Transient EN61000-4-4, Criterion A
Conducted Immunity EN61000-4-6, Criterion A
Typical Characteristics
Efficiency (%)
100
20
10
Output Voltage (V)
50
30
0
Vin = 24V, Iout = 300~1000mA
Efficiency (%)
100
20
10
Output Voltage (V)
50
30
0
Vin = 32V, Iout = 300~1000mA
Note:
1. All LED Drivers may not be used without a load. They must be switched on the primary side only.
Noncompliance may damage the LED or reduce its lifetime.
2. It is not possible to parallel the drivers to increase the current.
L-10 www.recom-power.comREV: 1/2016