Datasheet
26
www.recom-electronic.com
REV: 4/2011
Please Read Application Notes
LIGHTLINE
AC/DC-Converter
with 5 year Warranty
RACD60
RACD60
60 Watt PFC
Single Output
● 60W Class II AC-DC LED Power Supply
● Dual Mode CV or CC Output
● Power Factor Corrected
● Universal Input Voltage Range
● User Adjustable Current Limit (/OF)
● Thermal Feedback Dimming (/TOF)
● Waterproof Enclosure (/IP67)
● cUL/UL8750 Certified, CE Marked
● High Efficiency
● Long 5 Year Warranty
Features
LED DRIVER
Selection Guide
Part Output Output Factory Set Efficiency Output
Number Voltage Range Current Range Current (230VAC) Power
(min - max) (min - max) Limit Typ. Range
RACD60-4200* 11 - 13.5V 3570 - 4200mA 4.2A 85% 40-60W
RACD60-2400* 17 - 24V 2150 - 2500mA 2.4A 87% 30-60W
RACD60-2100* 21 - 28V 1400 - 2140mA 2.1A 89% 30-60W
RACD60-1400* 21 - 28V 1400 - 2140mA 1.4A 89% 30-60W
RACD60-1050* 38 - 54V 700 - 1100mA 1.0A 89% 27-60W
RACD60-700* 38 - 54V 700 - 1100mA 0.7A 89% 27-60W
* use suffix /OF for open frame version (standard) - output current limit adjustable with on-board trimmer
* use suffix /TOF for open frame version with thermal feedback - output current limit externally adjustable.
* use suffix /IP67 for waterproof potted version - fixed output currents only
Input Voltage Range All Versions 90-264VAC
Rated Power 60 Watts max.
Input Frequency Range All Versions 50/60 Hz
Power Factor Correction Full Load, 115VAC/230VAC > 0.9
Input Current (full load) 115VAC/230VAC 0.8A / 0.4A max.
Inrush Current (cold start) 115VAC/230VAC 25A / 50A max.
Leakage Current 230VAC/63Hz <0.7mA max.
Input Fuse Built-in 3.15A Slow Blow
Output Current Accuracy Full load ±5%
Output Current Adjust Preset Potentiometer (/OF) 75% to 100% approx.
External Voltage (/TOF)
Line Voltage Regulation LL to HL at Full Load ±4% typ.
Load Voltage Regulation 60% to 100% Load ±5% typ.
Minimum Load Current see table
Output Ripple and Noise 20MHz limited,with 0.1µF + 47µF 5Vp-p max.
Operating Frequency All Versions 65kHz typ.
Efficiency at Full Load see table
Isolation Voltage (60Hz RMS) input to output 3.75kVAC / 1 minute
input to filter ground 1880VAC / 1 minute
output to filter ground 500VAC / 1 minute
Temperature Coefficient All Versions ±0.02%/°C typ.
Overload Protection All Versions 105% typ.
Short Circuit Protection Continuous, Hiccup, Automatic Restart
Description
Specifications
(typical at 25°C and after warm up time unless otherwise specified )
The RACD60 is a compact universal input voltage
60W constant constant current power module
suitable for driving high power LEDs. The LED
driver has a dual mode of operation:-
CV mode: at loads below the preset current limit,
the RACD60 behaves as a fixed voltage source.
CC mode: at loads above the preset current limit,
the RACD60 behaves as a fixed current source.
Thus the same power supply can be used with
both CV and CC LED modules.
The RACD60 series have a universal input voltage
range with active power factor correction and are
fully protected against output short circuit, over-
load and over-temperature.
Three versions are available: a low cost open-
frame with either internal (/OF) or external user-
adjustable current limit (/TOF), and a sealed IP67
potted version (/IP67) with factory set output
currents for outdoor or high humidity applications.
UL 8750 Certified
cUL 8750 Certified*
EN 61347 Certified
RoHS
2002/95/EC
6/6
E340696
ordering examples:
RACD60-700/OF= open frame, adustable current limit preset to 700mA.
RACD60-1050/TOF=open frame,1050mA, adjustable 700-1050mA with ext. voltage or PWM signal.
RACD60-1400/IP67 = enclosed IP67 waterproof, non-adjustable 1400mA output.
Note: all currents within range are available - use RACD60-xxxx/IP67 where xxxx is the desired fixed current
e.g. RACD60-900/IP67 = enclosed IP67 waterproof, non-adjustable 900mA output.
* except 700mA/1100mA Versions