User manual

11
 PTZ Setting
 Type
Speed dome model type. Set: PTC-301, PTC-203ST, FUM 626,
JG_QG988, FUM 622SD, FUM 628 or off. Please select the correct
communication protocol if you enable this setting.
 Protocol
Speed dome protocol. Set: PELCO P, PELCO D, MIKAMI or off.
 Address
Speed dome address. Set: 0~255
 Baud Rate
Speed dome baud rate. Set: 1200, 2400, 4800, 9600, 19200.
 Tour Time
Speed dome tour time. Set: 5, 10, 15, 20, 25 sec or off.
 Tilt Opposite
Set speed dome image upside down. Set: On/Off
 Preset
Setup Operation
Front Panel &
Remote Controller
USB Mouse
Select Item [Up/Down/Left/Right] [Moving Cursor]
Enter Select Item [Enter] [Left Click]
Zoom +,-
Focus +,-
Iris +,-
Adjust Move Speed
Set PTZ Up/Down/Left/Right
Start/Stop Auto Tracking